DJI SDK Forum Help Center home page
Community Submit a request
Sign in
  1. DJI SDK Forum
  2. Onboard SDK
  3. Hardware connection

Hardware connection

Follow New articles New articles and comments
  • OSDK reported an error: heart beat task send failed
  • Does OSDK have any guidance on the development of third-party onboard computer platforms? Such as Raspberry Pi
  • OSDK adapter board coaxial cable pin definition
  • Installation dimensions of M300 OSDK adapter board
  • What are the capacitive loads and characteristics of the 24v power supply interface of the M300 OSDK adapter board?
  • After the M300 OSDK serial port is re-plugged, the OSDK reports an error "OSDK lost connection with drone", how to recover?
  • Where is the heartbeat API of the OSDK from the drone? How to troubleshoot?
  • Hardware connection between the onboard computer, DJI Assistant2 and M300
  • After the M210 is connected to the OSDK serial port, an alarm tone appears. and it is normal to disconnect the serial port
  • OSDK adapter board coaxial cable USB-C adapter male/female type?
  • OSDK STM32 platform UART port change
  • How to use CAN2 on A3/N3/M600 flight controller with SDK?
  • Is it possible to use an MCU without USB peripherals as an OSDK development board?
  • OSDK serial port communication failed, error ERRORLOG/1 @ sendData, L423: Port closed. ERRORLOG/1 @ sendData, L427: Open Protocol cmd send failed, send_len: -1 packet_len: 22
  • Onboard computer platform supported by DJI OSDK
  • When OSDK is connected to the UAV serial port, is it possible to directly connect to uart without using ttl to usb?
  • Is it possible for OSDK 4.x to connect to the drone only via USB or only via serial?
  • How does M300 power the OSDK onboard computer?
  • What is the serial port model of the OSDK adapter board
  • How to check that the API port on the A3/N3/M600 device is working properly
  • ERRORLOG/1 @ initVehicle, L162: Failed to initialize ACM Linker channel!
  • Does OSDK4.x for STM32 have to run on freeRTOS?
  • After the Manifold2 is connected to M300 , the DJI Pilot APP prompts that the voltage of the OSDK device is too low, how to solve it?
  • What is the protocol used by OSDK?
  • OSDK serial communication failure troubleshooting suggestions
  • Serial device cannot be recognized on 2C
DJI SDK Forum
简体中文