OSDK reported an error: heart beat task send failed
Does OSDK have any guidance on the development of third-party onboard computer platforms? Such as Raspberry Pi
OSDK adapter board coaxial cable pin definition
Installation dimensions of M300 OSDK adapter board
What are the capacitive loads and characteristics of the 24v power supply interface of the M300 OSDK adapter board?
After the M300 OSDK serial port is re-plugged, the OSDK reports an error "OSDK lost connection with drone", how to recover?
Where is the heartbeat API of the OSDK from the drone? How to troubleshoot?
Hardware connection between the onboard computer, DJI Assistant2 and M300
After the M210 is connected to the OSDK serial port, an alarm tone appears. and it is normal to disconnect the serial port
OSDK adapter board coaxial cable USB-C adapter male/female type?

See more

After the Manifold2 is connected to M300 , the DJI Pilot APP prompts that the voltage of the OSDK device is too low, how to solve it?

kyle.cai

August 25, 2021 03:12
Updated

Keywords: OSDK device voltage is too low

It is known that some M300 drones have such a problem. This problem does not affect normal use. Please try to solve it by upgrading the firmware.

Note: This article is from Chinese and is translated by machine. If there is any error, please point it out and we will correct it in time

Comments

0 comments

Please sign in to leave a comment.

close