Umesh
- Total activity 24
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 7
Activity overview
Latest activity by Umesh-
Umesh commented,
The RC was off throughout the entire mission as I'm flying without the RC, so I didn't open or close it during the mission. The mission I'm testing is the same sample mission provided in the PSDK s...
-
Umesh commented,
The end action is set to `DJI_WAYPOINT_V2_FINISHED_GO_HOME`. I have also tried different end actions like `DJI_WAYPOINT_V2_FINISHED_AUTO_LANDING` and `DJI_WAYPOINT_V2_FINISHED_GO_TO_FIRST_WAYPOINT`...
-
Umesh commented,
I'm working on the same. I'm taking the KMZ file and transferring the mission configuration, waypoints, and actions required for the payload into Waypoint V2 format. This allows the mission to be p...
-
Umesh created a post,
Waypoint V2 Mission Error: Mission Exits Without Executing Finish Action
After reaching the last waypoint, the Waypoint V2 mission is entering the mission exit state with an error code and is not executing the designated finish action to return home. The following l...
-
Umesh commented,
The issue with descending past 0.7 meters was due to the downward obstacle avoidance sensor being active, which restricted the descent. After turning off the downward obstacle avoidance sensor, the...
-
Umesh commented,
Thank you DJI Developer Support team, it's working after disabling the rtk from pilot application.
-
Umesh created a post,
Difficulty in Descending Drone Using DJI_FLIGHT_CONTROLLER_VERTICAL_VELOCITY_CONTROL_MODE
CompletedI'm unable to descend the drone after it reaches 0.7 meters altitude when using the DJI_FLIGHT_CONTROLLER_VERTICAL_VELOCITY_CONTROL_MODE for the vertical channel. Is there a specific reason for thi...
-
Umesh commented,
I'm encountering the following error: ```[12.462][waypoint]-[Error]-[DjiWaypointV2_Start:377) Use rtk_data but rtk is not connected or rtk_data is invalid [12.462][user]-[Error]-[DjiTest_WaypointV...
-
Umesh commented,
Thank you for answering my query. How can I obtain control authority from the PSDK sample code, or do I need to make changes to the code?
-
Umesh created a post,
Unable to Perform Sample V2 Waypoint 2.0 - Run Airline Mission on M300 RTK
CompletedI encountered the following error while attempting to perform the Sample V2 Waypoint 2.0 - run airline mission: [14.543][user]-[Info]-[DjiTest_WaypointV2RunSample:96) Waypoint V2 sample start[14.5...