Cloud Api Error "device not connect"

关注

Loic Helec

• 2024年06月27日 13:59

I use docker to deploy the environment for the Cloud API but when i login with the controller I have this error: "device not connect"
I wait 10 minutes and the error continued

I don't know if it could be due to the EMQX configuration, the environment was deploy with docker so there should be no errors and the IP a put is the same as the one on the machine, should it be another IP ?

0

• 

  marderary

  • 2024年06月28日 02:16

  1.There is no need to deploy in another IP
  2.Look at this is Disconnect,it could be mq configuration incorrect.

  

  0

  评论操作 固定链接
• 

  DJI Developer Support

  • 2024年06月28日 03:24

  Dear developer, Hello, thank you for contacting DJI DJI Innovation. This is because the drone is not turned on, or it is not synchronized with the remote control when turned on. Reason: The H5 interface obtained the drone SN of the remote control frequency through the JSBridge interface, and then requested the backend through the drone SN. The backend did not have any drone related information, resulting in an error message "device not found". Solution: Turn on the drone and keep it in frequency synchronization with the remote control. I hope our solution can help you. Thank you for your email and I wish you a happy life! Best Regards, DJI DJI Innovation SDK Technical Support

  0

  评论操作 固定链接
• 

  Loic Helec

  • 2024年06月28日 14:03

  The aircraft was synchronized with the controller, we check it looking at the camera of the dron in the controller. @DJI Developer Support

   

  Thanks @marderary i will try to check the mq configuration

  0

  评论操作 固定链接

请先登录再写评论。