DJI Diagnostics Details in V5
已完成
Hiiii support team,
In MSDK V4 that DJI provide a Json file on Device Health Information: https://github.com/dji-sdk/Mobile-SDK-Android/blob/master/hms.json . Just wondering can MSDK V5 also provide something similar to this please? If the file is not currently being provided, would you mind tell me where and how to receive "Aircraft Antenna Satellite Signal Searching Error" in V5 please
In MSDK V5 Device Status, it has CANT_TAKEOFF and CANT_TAKEOFF_HMS. Would you mind provide me more details on those two please? Like when Device Status update its current status with CANT_TAKEOFF, is it referring to generic cant take off error or downward sensor has error thus drone can't take off?
Thank you very much!
-
Just wondering can MSDK V5 also provide something similar to this please? If the file is not currently being provided, would you mind tell me where and how to receive "Aircraft Antenna Satellite Signal Searching Error" in V5？ -->The method `addDJIDeviceHealthInfoChangeListener` can be used to listen for detailed diagnostic information such as "Aircraft Antenna Satellite Signal Searching Error". Would you mind provide me more details on those two please? Like when Device Status update its current status with CANT_TAKEOFF, is it referring to generic cant take off error or downward sensor has error thus drone can't take off? -->"CANT_TAKEOFF" and "CANT_TAKEOFF_HMS" can't be distinguished from each other. Have you encountered both of these states on the same aircraft? Additionally, "CANT_TAKEOFF_NOVICE" refers to the inability to take off due to a lack of GPS signal. -
Helllooo support team,
I'm using addDJIDeviceStatusChangeListener to monitor the device status update, and encounter a weird behaviour. I'm currently using MSDK 5.4 with M300 and smart controller with latest firmware.
When I connect my tablet with the controller, addDJIDeviceStatusChangeListener update the current device status with "Aircraft disconnected" with SERIOUS_WARNING, but when I check with DJI Pilot App, there is no any aircraft disconnected warning. Just wondering if this's expected behaviour?
Thank you so much support team!
-
Could you provide us with a video to visually understand the issue? Does the issue also occur on the sample? Is it a consistent problem? The Pilot 2 can read the connection, but the MSDK cannot, which is not a performance we expect. Here is the upload address: (https://pan-sec.djicorp.com/s/tQSwT4t4BaSoQSm).
请先登录再写评论。
评论
3 条评论