Simulator - Drone is not starting engine

已完成

关注

Dennis Tietz

• 2023年07月24日 18:17

Hi all, 

I'm starting to develop an Android app for a DJI drone. I'm new to the DJI environment and the drone itself. For this I want to debug and test the drone in my office.

I have connected my DJI Matrice 300 RTK via USB to my PC and it is reconized by DJI Assistant 2. I successfully updated the firmware. I can launch Simlator for the drone without errors.

My remote M300 reconizes the Simualtor because it changes the status of the drone. However, I cannot start the motors by pushing the sticks inwards. Also, there is no manual flight menu at all. 

The preflight check on the remote still shows a warning for the avionics. It says that the airplane is restricted from flying because of the area. It says "P mode - unable to take off".

I have no idea how to proceed. Can someone please help me?

Regards,

Dennis

0

• 

  DJI Developer Support

  • 2023年07月25日 07:32

  You need to set the latitude and longitude of the aircraft's location before start the simulator. Please make sure that the latitude and longitude set in the simulator are close to your location. And the latitude and longitude should not be located in the no-fly zone.

  0

  评论操作 固定链接
• 

  Dennis Tietz

  • 2023年07月25日 12:00

  Thank you! That worked for me!

  I change the latitude and longitude in DJI Assistant 2 before starting the simulator. 

  0

  评论操作 固定链接

请先登录再写评论。