Can not get clean serial connection from M600 Pro to Arduino

Follow

Philipp

• March 31, 2020 12:12

I have a DJI M600 Pro connected to a software based serial port on an Arduino Uno and I am not receiving a clean signal.

The baud rate in DJ Assistant was set to 115200 and the same goes for the Arduino Serial Monitor. In DJI Assistant enabled the API and disabled all outputs except for the GPS data and set it to 1HZ to make it easier to read for testing.

I can see data flying in with 1HZ but the serial output Is mostly question marks and some letters in-between.

Is the serial data encrypted? If so, how can I decrypt it?

Here's the code:

 

#include <SoftwareSerial.h>

SoftwareSerial mySerial(2, 3); // RX, TX

void setup()
{
  // Open serial communications and wait for port to open:
  Serial.begin(234000);
  while (!Serial) {
    ; // wait for serial port to connect. Needed for Native USB only
  }


  Serial.println("Goodnight moon!");

  // set the data rate for the SoftwareSerial port
  mySerial.begin(234000);
  mySerial.println("Hello, world?");
}

void loop() // run over and over
{
  if (mySerial.available())
    Serial.write(mySerial.read());
  if (Serial.available())
    mySerial.write(Serial.read());
}

0

• 

  Olli Rinta-Filppula

  • November 30, 2022 14:37

  Hey,

  Same problem 3 years later, did you manage to get it working somehow?

  Does support have anything to say to this? 

  Connection: Matrice 300RTK -> Expansion board -> UART TTL to USB -> Windows PC Serial read.

  Data is flowing but its nonsense/garbage.

   

  Thanks!

  0

  Comment actions Permalink

Please sign in to leave a comment.